- 10 小时
发表于 2009-12-7 15:02:31
keywords:outdoor gym outdoor fitness equipment outdoor exercise equipment |
Electric treadmill running machine imported dedicated by the composite material made of Nylon, a low coefficient of friction, high tensile strength; running board while using a unique dual-damping system, the top of the layout of urea-formaldehyde resin finish high, super - Strong wear-resistant, making movement more comfortable and smooth.
Kept clean and can greatly improve the life of treadmill should always wipe exposed on both sides of runs with a running board and pedal to reduce the dust and dirt accumulation in the running with the following. Can be used to run with a soft cloth dipped in soapy water, pay attention not to let water flow into the run vaginal discharge and retaining shell.
Treadmills used for a period of time, must use special lubricant on the running board / Running belt lubrication is recommended that:（ outdoor gym ）
The use of time is less than 3 hours per week for six months lubrication time
3-6 hours usage time per week for three months once Lubrication
Use of time more than 6 hours per week lubrication once a month,
Tu lubricants ways: treadmill with special tools to adjust the left and right rear bolt release, will run with a lift-off 10CM-15CM up about the right amount of special lubricants into the running board top surface, smear evenly, and then run tighten the belt. (Adjustment method, see "Running with elastic adjustment method")
Can not be over-lubrication, lubricant is not possible, remember: a reasonable service life of lubrication is to raise an important factor in treadmill!
Unclean or lubricants will cause less to run w / running boards friction increases, may be motor, control panel damage. Too much friction has the following characteristics:
1, power state, running with the pedal with a very demanding and even tread is not moving;
2, the load medium-speed treadmill running, pull down the safety switch, running with an immediate and full stop;
3, friction increases, may cause damage to electrical or control panels, short-circuit tripping device, fuse fuse so.
Running with elastic adjustments:
1, all the treadmill factory should be carried out before and after installation to run with the adjustment, but use may also occur after a period of relaxation, running with loose warranty does not belong to the scope of the main by the user on their own maintenance. Running with too loose, then, when stepping on the running belt, running between the belt and the roller will produce skid phenomenon, but is not too tight, with the possible damage to motors, belts and rollers such as running. Under normal circumstances, both sides can be run with a lift-off running boards suitable 5-6cm.
To determine a way to run with too loose: outdoor exercise equipment
Treadmill speed will be adjusted to 1.5KM / H, two-handed force to seize the rails, with their feet running forward energetically with a block transfer, such as the running belt to stop turning, but before the drum is still running, running with a loose power continued to operate after this phenomena show that the running belt too loose, the user will pause feeling, long-term use will reduce the run with a life. Should be timely adjusted.
2, run with elastic adjustment method: using the treadmill for some time, in the above pause when running phenomenon, which is due to run with an over-making.